Alien Reproduction Vehicle

Though I will not recommend using his variation due to the fact that if you attempt to load your free energy too fast, the ferrite might due to the temperature dropping too fast as the ferrite is operating on a different time rate and imperfection in the distribution of rotating magnetic field causes time rate variations in the ferrite and in turn sharp temperature variations and pressure change can causes it to crack.
 

Dejan Corovic

As above, so bellow
gravitational potential field is the gradient of the divergence of the magnetic vector potential field.

how did you work out this one?

So, magnetic vector potential A has both curl and gradient?

is there a way to visualise that? How does gradient of divergence looks like?
 
Last edited:
how did you work out this one?

So, magnetic vector potential A has both curl and gradient?

is there a way to visualise that? How does gradient of divergence looks like?

Sorry, I made a mistake

Gravitational potential field is the divergence of the magnetic vector potential field while Gravitational force field is the gradient of the divergence of the magnetic vector potential field or simply put, the gradient of the gravitational potential field.

As for visualization of the divergence of the magnetic vector potential field, it is like water flowing down the drain, the lines of potential fields all point towards a central point from all around the point or away for the point depending on whether the force field is attractive or repulsive.

Read the PDF titled "an introduction to scalar physics" from Transcending the Matrix Control System search the site for the pdf
 

Dejan Corovic

As above, so bellow
Sorry, I made a mistake

Gravitational potential field is the divergence of the magnetic vector potential field while Gravitational force field is the gradient of the divergence of the magnetic vector potential field or simply put, the gradient of the gravitational potential field.

As for visualization of the divergence of the magnetic vector potential field, it is like water flowing down the drain, the lines of potential fields all point towards a central point from all around the point or away for the point depending on whether the force field is attractive or repulsive.

Read the PDF titled "an introduction to scalar physics" from Transcending the Matrix Control System search the site for the pdf

Thanks!

Its not easy to find, but here is a very nice overview and top-down summary:

The Etheric Origins of Gravity, Electricity, and Magnetism | Transcending the Matrix Control System

Here is a link to the page from which one can access the "An Introduction to Scalar Physics" paper:

Ether Physics | Transcending the Matrix Control System
 
Sorry, I made a mistake

Gravitational potential field is the divergence of the magnetic vector potential field while Gravitational force field is the gradient of the divergence of the magnetic vector potential field or simply put, the gradient of the gravitational potential field.

As for visualization of the divergence of the magnetic vector potential field, it is like water flowing down the drain, the lines of potential fields all point towards a central point from all around the point or away for the point depending on whether the force field is attractive or repulsive.

Read the PDF titled "an introduction to scalar physics" from Transcending the Matrix Control System search the site for the pdf

or whether the potential fields is positive or negative.
 
... and that potential, is it scalar or is it, what they call, 4-vector?

well the superpotential field, electric potential field are scalar while only the gravitational potential field and magnetic vector potential field are vector quantity.

all those 4 vector stuff, I don't really give a dam about those stuff as it does not add any value to my store of knowledge and understanding. it just makes things seem more complicated than they really are.
 
well the superpotential field, electric potential field are scalar while only the gravitational potential field and magnetic vector potential field are vector quantity.

all those 4 vector stuff, I don't really give a dam about those stuff as it does not add any value to my store of knowledge and understanding. it just makes things seem more complicated than they really are.

As for the whether the gravitational potential field is a scalar or vector quantity you have to check in physics text. I think it is actually scalar. The rest are certainly correct.
 
Dejan, have you ever wondered why ectoplasma or the passage of a ghost through a human body is noticed as cold (falling temperature)?.

This is because in order to gather ether 1,2,3 into a structure that can assemble gross form made of elements, gases, liquid and solid to form a human body, you need to modify the attractive forces between the first three States of matter and the only way to do that is by modifying the rate of time flow as measured by the particles.

All particles have an internal clock which keeps track of activities as performed by the particle. All activities includes even when the particle is at rest or stationary.

The property of a particle having mass is directly linked to internal rotation. All activities as measured in time is referenced to the time it takes to complete one internal rotation. So mass is proportional to the Internal rotation which is proportional to the rate of time as experienced by the particle.

A particle or group of particle might have mass in one dimension and be massless in a lower dimension. This is because there are many degrees of rotation. You can have rotation within rotation as you know.

I have learnt or rediscovered so much knowledge that I can't wait to implement just a few at least.
 

spacecase0

earth human
I would like to bring to our notice a topic that I think deserve a separate thread even though it is related to the MAGVID device.

The device in question is the FLOYD SWEET free energy device. After analysing the description and pictures of the plan of the device left by Floyd sweet, I have discovered that his device is simply a MAGVID inverter that uses only one ferrite core instead of the four recommended here. By using two coils placed at 90 degrees on the single block of ferrite, the rotating magnetic is generated internally in the ferrite instead of outside the ferrite as you will get if you use a four coil system.

By using this technique, the time shifting occurs within the single block of ferrite as the magnetic field is rotating within the block of ferrite due to the two coils placed at 90 degrees on the ferrite.

The output coil is then coiled 90 degrees or perpendicular to the two input coil to get your output.
that sounds easy enough to build,
my question is how to figure out what frequency to put in to get the proper vortex.
just testing frequencies is not that easy with the hardware I have.
 

spacecase0

earth human
Dejan, have you ever wondered why ectoplasma or the passage of a ghost through a human body is noticed as cold (falling temperature)?.

This is because in order to gather ether 1,2,3 into a structure that can assemble gross form made of elements, gases, liquid and solid to form a human body, you need to modify the attractive forces between the first three States of matter and the only way to do that is by modifying the rate of time flow as measured by the particles.

All particles have an internal clock which keeps track of activities as performed by the particle. All activities includes even when the particle is at rest or stationary.

The property of a particle having mass is directly linked to internal rotation. All activities as measured in time is referenced to the time it takes to complete one internal rotation. So mass is proportional to the Internal rotation which is proportional to the rate of time as experienced by the particle.

A particle or group of particle might have mass in one dimension and be massless in a lower dimension. This is because there are many degrees of rotation. You can have rotation within rotation as you know.

I have learnt or rediscovered so much knowledge that I can't wait to implement just a few at least.
I figured it was because things were extracting energy from reality,
attached is the inductive version and the capacitor version

but I like your idea, it is likely to be more accurate.
 

Attachments

  • Capacitance converter.pdf
    239.8 KB · Views: 2
  • zaev1.pdf
    319.2 KB · Views: 1

spacecase0

earth human
What do you guys say about this Thomas Bearden's video:


View: https://youtu.be/z-pTERbyEsY

the key to what he did appears to be permanently charged dust.
here is what I made to separate.

View: https://youtu.be/iTaPWXn9eP8

and all it seems as if you need to do is to activate it with a tesla coil.
anyway, lots of research to do here.
most of this mess appears to be an implementation issue.
you need lots of charge in a small area with an isolated voltage supply, and this is one way to get it
 
that sounds easy enough to build,
my question is how to figure out what frequency to put in to get the proper vortex.
just testing frequencies is not that easy with the hardware I have.

start with a minimum internal rotating magnetic field strength of 500 guass and frequency of 1 mhz. Monitor the output voltage to avoid damaging your filter capacitor.
 
I figured it was because things were extracting energy from reality,
attached is the inductive version and the capacitor version

but I like your idea, it is likely to be more accurate.
you are very correct. Energy flows from a region of slower timerate to a region of faster timerate.

the ghost particles are time excited, so they pull energy from their surrondings.
 
start with a minimum internal rotating magnetic field strength of 500 guass and frequency of 1 mhz. Monitor the output voltage to avoid damaging your filter capacitor.

output voltage can simply be controlled by adding a variable inductor to detune the series lc circuit and reduce the power fed to the rotating magnetic field.
 
i have prepared a bill of materials for a 5KW Free energy electrical generator and have done a cost estimate for all of them including recurring and non-recurring cost but one item that i have not estimated its cost is the soft ferrite that is needed for the electrical generator.

This soft ferrite needs to be custom machined to needed dimensions.

Spacecase0 and Dejan, i will your assistance in contacting the companies that i will post here inorder to get a price quote. I will also post neccessary specifications like type of magnese-zinc ferrite to be used and required shape and dimensions.

My smartphone is damaged so while i have joined the discord link, it will be a while before i will start posting there. When i start though, i will post my DIY there.
Thanks for posting the discord link.
 
Top